Gothic Pumpkin Soaps From SoapyLove

Supplies for 2 bars of soap:

(you can get everything from Bramble Berry except for transfer sheet which is from Fancy Flours)

8 oz of clear soap base
Silver mica
Black oxide (optional)
Pepperberry fragrance oil (or any you like, but this has a really nice spicey scent)

Heavy duty octagon mold (or any flat faced mold you have)

"Floral Scroll Black" chocolate transfer sheet from Fancy FloursKnife, cutting board, scissors, rubbing alcohol in spray bottle, yadda yadda.

1) Choose a design that has very little detail. Sketch it on paper first and make sure it will fit in your mold.

2) Cut your shape out of your transfer sheet. Be very careful to avoid touching the rough side, since it's very sensitive and can smudge easily.

3) Touch your finger into a drop of vegetable oil or liquid glycerin and apply a thin coat to the mold where you will put your design. Place your design, SMOOTH SIDE DOWN, into the mold and use a pencil to touch the transfer gently and make sure it's completely stuck down. You don't want any air pockets where the soap can sneak under.

4) Melt 6-8 ounces of clear soap base (depending on the capacity of your soap molds) by cutting soap base into small chunks (dice sized), and heat at full power in a microwave for 30 seconds. Stir until all remaining chunks are melted. Dissolve a pea sized amount of silver mica in a 1/4 teaspoon of rubbing alcohol and stir into melted soap. You can add a touch of black (dissolved in alcohol again) if you would like a deeper shade like I have. Stir in 3 mL of fragrance oil (completely a personal choice. Use more or less!)

5) LET SOAP COOL A LOT! You need to pour this super super cool. If a skin is forming on the surface, that's good! It should be between 110-115 degrees. Now pour into your mold, but pour at the edge of the mold so the soap runs over your design. Do not pour directly onto the transfer.

6) Allow soaps to harden completely overnight. Unmold by inverting mold and pushing on the back with your thumbs until soaps pop out. Gently pry an edge of the plastic up and peel off. Voila!You can wrap these soaps in Saran Wrap and close the ends at the back with tape or a sticker, or put in a treat bag and tie tightly with a ribbon.

If you like this technique please check out more projects in my book, or if you're in the Halloween spirit please check out my latest issue of Let's Get Soapy which is chock full of soapy tricks and treats! Thanks!

Source: http://soapylove.blogspot.com/2009/09/gothic-pumpkin-soaps.html